Job Description

Rigger Shop MechanicThe Rigger Shop Mechanic performs a variety of skilled mechanical duties involving deck machinery, engine room work, electronic equipment, staging work, testing, steel/pipe work, general dock, rudders, shafting, wheel work, and anchor chain work. The Mechanic operates equipment for assembly and installation; performs preventative and predictive maintenance on facility machinery; records work performed and follows specified safety policies and procedures.Key Responsibilities & Functional Knowledge: This list is representative of the key areas of responsibility and functional knowledge required of a mechanic in the rigger shop. A mechanic must demonstrate a developing knowledge of the skills, functional knowledge and abilities required to perform tasks in these and related areas of responsibility. Developing knowledge means that the mechanic understands how to perform tasks in these categories (including, but not limited to, the specific tasks identified below) and is able to complete them with minimal assistance. This also means that the mechanic has the necessary level of knowledge of the equipment, protective gear, and machinery required to complete these tasks. In some cases, as specified, the mechanic is expected to assist, rather than completing the task independently.Anchor Chain WorkMake metal tagsBreak detachable links (including baldt/kenter style links)Transport – load/unload – trailers/pallets (Preferred)Read a micrometerAssist in counting anchor shots and tagsAssist in removing and reinstalling bitter ends – open/closed fo'c'sleAssist in measuring chain links and detachable links including snap gauge shotsWheel Work (Hubs/Blades/CCP System)Hook up and operate air fallsInstall and remove blade pallet rigTransport hub – trailer/boom dolly (Preferred)Assist in proper sling/grommet hook up – hullDry-Dock Related Shafting WorkAssist in method of removal - pad eye placement – select gearAssist in shaft transporting – trailer/boom dollyShaft Alley Related Shafting WorkRemoval of bulkhead sealsDeck Machinery Work (work with cranes and cargo booms)Wires – Assist with removing/reeve system/blocksBooms – Assist with removing /install and proper method/gear selection for ABS quadrennialBlocks – Assist with removing /reinstall [ABS quadrennial]Testing – Assist with setting up, [navy test] [ABS test]B&A crane – Assist with removing /reeve wire ropesB&A crane – Assist with boom removal [method/select gear/block/transport]B&A Crane – Assist with testing and set upRoutine Engine Room WorkMethod/gear/route walkedProper lashing/rig gear applicationsSmall pumps, motors, valves [less than 24"], pipe, vent ducting, etc.Install and remove flushing gearMain Engine/SSDG Overhaul WorkInstall and remove flushing gearElectronic Equipment InspectionsComplete inspection proceduresDetermine follow up requiredStaging WorkMust be familiar with the staging procedureMust be familiar with proper building practices for the QES/BurkeSteel/Pipe Related Work:Complete steel repair work and or piping work on various areas outside of the engine roomGeneral Dock-Related WorkBlockingDocking/undockingMooring shipsGangway/platformsOther various dock-related tasksMust be familiar with Hook-on (ship/pier)Must be a candidate for the Maritime Solutions Norfolk Hiring EventsMinimum education requirements: High school diploma/GEDMinimum relevant experience: 4-7yrs.Must be able to read, write and comprehend simple instructionsMust be able to apply common sense understanding to carry out instructions in written, oral or diagram formMust be able to calculate and understand units of measureMust be able to wear appropriate protective gearMust be able to obtain a government access badge.

Job Tags

Similar Jobs